I’m not normally very crafty, but when I found instructions on how to make a shrunken head pumpkin I decided to give it a go. It was a fun way to add some Halloween decorations to the tiki room in our new house, and it wasn’t too difficult. The most annoying and time-consuming part was poking holes in the top of the foam pumpkin and threading the raffia through them.
INSTRUCTIONS (via Michaels.com)
Small Gourd – White
Craft Foam – White
Wooden and Colored Beads-Assorted
Hot Glue Gun and Glue Sticks
Cut a hole in bottom of Gourd, large enough to fit your hand inside.
Cut a series of 16 holes in the top, in a circular pattern. These should be large enough to thread double-thick strands of raffia through.
Thread double thickness of raffia down through a hole in the top, and then thread it back up through the hole next to it, so the ends of raffia stick up out of the top of the Gourd like hair. Repeat until all holes are filled. You may use different colored raffia to create a custom look.
Gather raffia into a ponytail at the top of head’, and wrap with loose raffia.
Step: 5 (I skipped this step)
Cut out a bone from white craft foam and hot glue behind wrapped area of raffia.
Draw on face with a pencil, and carefully cut out with Exacto knife. You may carve only the surface to create a relief effect, as shown.
Cut holes on top and bottom of mouth line and thread raffia through the holes to create a stitched mouth.
Hot glue wiggle eyes in place.
Select two strands of raffia toward the front of the head’ and string with wooden and colored beads. Tie a knot in the end and trim to desired length.
Do you put up any tiki-themed Halloween decorations? Tiki Central has a thread on Tiki Bar Halloween Decor that can give you more ideas. Happy Halloween!
Enchanted Tiki Room Painted Pumpkins at Disneyland
Halloween 2010 Art Show at the Tonga Hut
Spooky Tiki at Halloweentown in Burbank
Hey, Happy Hallowe;en!